Eurotech Support Forums - Installing New Bootloader Failed

All Forums

Hardware

General Hardware, ADSmartIO, Digital I/O and A/Ds

Installing New Bootloader Failed

Forum Locked

Send Topic to a Friend

Printer Friendly

Author

Topic

gkondos

2 Posts

Posted - 03 Aug 2005 : 08:35:33

I recently installed the BitsyX linux 64MB DRAM bootloader (700115-450m) on a BitsyX device using the JTAG flash software in (720040-0031) and a Xlinx Parallel Cable IV. The process appeared to work successfully, however, the BitsyX won't boot an nothing at all is display to the console. Output from jflashmm is as follows...

JFLASH Version 5.01.003
COPYRIGHT (C) 2000-2003 Intel Corporation

*** ADS patch1 (FLASH unlock) ***
*** ADS patch2.1 (Verify failure fix) ***
*** ADS patch3 (Devices > 2 fix) ***

PLATFORM SELECTION:
Processor= DBPXA255
Development System= ADS255-1
Data Version= 1.0

DBPXA255 revision A0
Found flash type: 28F128J3A (Asynchronous)

Erasing block at address 0
Starting programming
Using BUFFER programming mode...
Writing flash at hex address 10f00, 99.62% done
Starting Verify
Verifying flash at hex address 10cf8, 98.87% done
Verification successful

I can reflash the BitsyX over and over with the same success but still can't get it to boot. What am I missing?

akidder

1519 Posts

Posted - 03 Aug 2005 : 10:59:15

If I recall correctly, you have a BitsyX with a special personality board. I think we have different boot code for that board from what is published on the forums.

Email us details about the BitsyX and personality board you are using, as we'll be glad to help.

Topic

Forum Locked

Send Topic to a Friend

Printer Friendly

Jump To:

Eurotech Support Forums

This page was generated in 0.03 seconds.

Snitz Forums 2000