All Forums
 Microsoft Windows CE
 CE Downloads and Documents
 Bitsy G5 CE Boot Code		  Forum Locked  Topic Locked
 Send Topic to a Friend
 Printer Friendly
Author Topic  

ljoy

22 Posts
Posted - 12 Oct 2007 :  15:29:55  Show Profile  Email Poster
Bitsy G5 Windows CE Boot Code

Instructions for updating the boot code are found in the Developer's Getting Started Guide.

Related topics: Bitsy G5 CE files page, Bitsy G5 User Manual

64 MiB DRAM
Bitsy G5

1.4 (Jan-2008)
- Added CPU frequency setting support (requires ADSLOAD.HWT 7014)

1.1 (Oct-2007)
- Initial release

grenierm

133 Posts
Posted - 14 Jan 2009 :  16:39:08  Show Profile  Email Poster
Bitsy G5 Boot Switch Settings:

The Bitsy G5 behaves differently than our other Bitsy Products, and differently than in the ‘CE Getting Started Guide’. Specifically, the DIP Switches tell the processor which memory to boot from. Given that there is only one type of memory on the board, they should be left in the state (DIP Switch 1=2=OFF) and not modified.

Instead, you must use the debug output (default usually set within the adsload.hwt to COM3, J18, of the Bitsy G5 Personality board) and take one of the following actions on boot-up:
- ‘Sealed Box Upgrade’ Mode: With CF Card inserted, simply don’t press the spacebar and the board will load the files from the CF Card
- ‘Debug’ Mode : Press spacebar within 5 seconds of booting to enter ‘Debug Menu’
- ‘Normal’ Mode : With CF Card NOT inserted, simply don’t press the spacebar and the board will boot to the desktop

Edited 28-Jan-2009 by grenierm: Clarify Normal and Sealed Box upgrade boot modes
Go to Top of Page
  Topic  
 Forum Locked  Topic Locked
 Send Topic to a Friend
 Printer Friendly
Jump To:
Eurotech Support Forums © Eurotech Inc. Go To Top Of Page
This page was generated in 0.02 seconds. Snitz Forums 2000