All Forums
 Hardware
 General Hardware, ADSmartIO, Digital I/O and A/Ds
 VGX J9 Ethernet Signals		  Forum Locked
 Send Topic to a Friend
 Printer Friendly
Author Topic  

innomatix

12 Posts
Posted - 20 Jun 2012 :  15:38:40  Show Profile  Email Poster
We are attempting to use the VGX Ethernet signals on J9 to support an alternative Ethernet connection to a second microcontroller. In testing, we noticed that there doesn't appear to be any continuity between pins J9.19-J9.22 and the input pins of the on-board RJ jack. If these are the same signals, I would have expected such.

Is there anything else we need to know/do to access these signals?

twhite

133 Posts
Posted - 20 Jun 2012 :  16:19:40  Show Profile  Email Poster
The Ethernet signals on the VGX board are not meant to drive two connections, as you have found. There are zero ohm resistors that are populated depending on which connection you wish, either the J9 connection or the RJ45, but not both.

If you would like more information on this, please email us at support.us@eurotech.com.
Go to Top of Page
  Topic  
 Forum Locked
 Send Topic to a Friend
 Printer Friendly
Jump To:
Eurotech Support Forums © Eurotech Inc. Go To Top Of Page
This page was generated in 0.02 seconds. Snitz Forums 2000