All Forums
 Hardware
 Cables and Connectors
 Debug cable 610110-4004B (GM/GC+ Serial 3)
 Forum Locked
 Send Topic to a Friend
 Printer Friendly
Author Topic  

Joelw

30 Posts

Posted - 13 Sep 2002 :  14:12:27  Show Profile  Email Poster
Question using RS-232 cable 610110-4004B with GM:

Pin-out in GM manual for 2x5 header is as follows:
1 - dcd
2 - dsr
3 - rxd
4 - rts
5 - txd
6 - cts
7 - dtr
8 - n/c
9 - gnd
10- n/c

The cable pin-out is as follows:
1 - no connection (n/c)
2 - n/c
3 - pin 2 of DB-9M
4 - pin 7 of DB-9M
5 - pin 3 of DB-9M
6 - pin 8 of DB-9M
7 - n/c
8 - pin 9 of DB-9M - ??
9 - pin 5 of DB-9M
10- n/c

What is the purpose of IDC 8 to DB-9M pin 9??
Is this only for strain relief of the ground conductor,
DB-9 pin 5??

Regards,
Joel Winarske

akidder

1519 Posts

Posted - 13 Sep 2002 :  17:35:29  Show Profile  Email Poster
#Serial 3 Loopback

Hi Joel. The short answer is that the 4004A cable is designed for quick assembly, and there are a number of pins that are unused in it. You don't need to connect them in your own cable.

Here's the longer answer...

The 610110-4004A cable is used to convert the J10:Serial_3, 2x5 header of the GC Plus, GMaster and other products to a DB9 connector suitable for use with standard serial ports.

Only a few of the ten pins on the 2x5 header are actively used by the GC Plus and GMaster. Four are signals, three are loopbacks, two are unconnected and one is ground. You may connect as few as three wires to create a valid RS-232 serial cable.

The pinout for the 2x5 socket was designed to simplify cable assembly. You can quickly crimp IDC and DB9 plugs onto a nine-pin ribbon cable to create the 4004A cable.

Its cousin, the 4004B (below) includes a loopback of DTR, DSR and DCD to the PC for use with CE ActiveSync, which increases the complexity of cable construction. Take a look at this cable drawing for the low-down on which signals are connected by the cable.

610110-4004B cable (PDF)


Related topics: ADS Development System Cables

-----------------------
Drew Kidder
ADS Technology Transfer

Edited by akidder 27-Jan-2003: Correct link to -4004B drawing
Edited by akidder 1-Apr-2004: Add link to dev system cable topic
Go to Top of Page

akidder

1519 Posts

Posted - 27 Jan 2003 :  13:36:36  Show Profile  Email Poster
The following 2x5 IDC connectors can be used to create the 610110-4004B cable:

AMP #746285-1, BERG #66900-310, ADM #FCS10SG.

Equivalent crimp-and-poke connectors may be used as well.
Go to Top of Page
  Topic  
 Forum Locked
 Send Topic to a Friend
 Printer Friendly
Jump To:
Eurotech Support Forums © Eurotech Inc. Go To Top Of Page
This page was generated in 0.02 seconds. Snitz Forums 2000