All Forums
 Microsoft Windows CE
 CE Flash, CF and PCMCIA
 PCMCIA Spec? (power available)
 Forum Locked
 Send Topic to a Friend
 Printer Friendly
Author Topic  

dandvan

2 Posts

Posted - 08 May 2003 :  18:42:41  Show Profile  Email Poster
I've seen a lot of references to the PCMCIA spec, but have not been able to find a copy of it. Specifically, I'm looking for how much power is supposed to be provided by a PCMCIA slot...per the spec. It looks like the graphics master is only rated to 500 mA at 5V.

akidder

1519 Posts

Posted - 09 May 2003 :  13:34:58  Show Profile  Email Poster
The PCMCIA standard limits supply current to 500mA per pin, of which there are two on the PCMCIA socket. CompactFlash specification 1.4 limits current to 500mA per socket.

The Graphics Master power ratings are conservative and are primarily rated based on the power transistors we use. We've found that with the exception of a few very high current devices, 802.11, modem and storage cards work well in the Graphics Master, Graphics Client Plus, AGC and Bitsy. Our latest product releases (Bitsy Plus, BitsyX, etc) supply more current than in previous designs.

I've posted some PCMCIA/CF references at topic 947 if you are interested in reading further. I hope this information helps!

-Drew
Go to Top of Page

dandvan

2 Posts

Posted - 09 May 2003 :  16:57:36  Show Profile  Email Poster
Then what you're saying is that the total power available from the regulator on the Graphics Master should be 1A at 5V? Because that is not what we're seeing in our preliminary tests. We have loaded down this supply (at pins 17 and 51) with a mere 400 mA and noticed a 250 mV drop to 4.75V. The Graphics master will not turn on with a 600 mA load...this falls far short of 1A.

We have also seen turn on problems with the RangeLan2 wireless lan adapter and the Ambicom WL1100B 802.11 card. Both look like power problems. Can you explain to me how the power gets from the 3.3 and 5V that we supply to the PCMCIA card? Do you guys re-regulate or simply go through some sort of FET switch to control power?
Go to Top of Page

akidder

1519 Posts

Posted - 13 May 2003 :  12:07:01  Show Profile  Email Poster
Hi Dan. We use transistors to enable power to the PCMCIA and CF slot (that's one of the features that gives the sockets their hot-swappable functionality). As you noted in the Graphics Master specifications, we rate the socket at 500mA.

You might be seeing a voltage drop across the transistors, though I would also make sure that you're not losing power through the wiring on the main power supply. Try probing pin 3 of JP1--a good, on-board test point for 5V--to determine the level of the 5V power supply. If 5V is low there as well as on the PCMCIA slot, you might increase the input 5V supply to 5.3V. That would give you a greater margin for PCMCIA/CF devices that drain higher current.

If you are still having issues, please don't hesitate to give me a call at 301.490.4007, extension 122.

Cheers, Drew
Go to Top of Page
  Topic  
 Forum Locked
 Send Topic to a Friend
 Printer Friendly
Jump To:
Eurotech Support Forums © Eurotech Inc. Go To Top Of Page
This page was generated in 0.02 seconds. Snitz Forums 2000