All Forums
 Hardware
 Ethernet, IR, Serial, CAN and high speed data
 Serial 2 Recv Line Malfunction
 Forum Locked
 Send Topic to a Friend
 Printer Friendly
Author Topic  

andio310

4 Posts

Posted - 28 Jan 2004 :  17:43:09  Show Profile  Email Poster
When I transmit data in RS232 from serial port 2 I see that receive garbage through the debug port as if I were using the incorrect baud(which I'm not). Also, when I try using CMOS logic the data is never received. However, in both cases I am able to receive data from the Bitsy. All jumpers were set as was stated in the manual including the documentation fix for the CMOS jumpers. Are there any other jumpers or settings I should be looking for? What could be causing this problem on the harware and software sides?

akidder

1519 Posts

Posted - 29 Jan 2004 :  16:36:10  Show Profile  Email Poster
Take a look at topic 1347 for a response.
Go to Top of Page
  Topic  
 Forum Locked
 Send Topic to a Friend
 Printer Friendly
Jump To:
Eurotech Support Forums © Eurotech Inc. Go To Top Of Page
This page was generated in 0.03 seconds. Snitz Forums 2000