All Forums
 Hardware
 Ethernet, IR, Serial, CAN and high speed data
 Data on serial port at startup? (AGX)		  Forum Locked
 Send Topic to a Friend
 Printer Friendly
Author Topic  

mfh

10 Posts
Posted - 17 Feb 2004 :  09:06:41  Show Profile
I have a device connected to port 3 on the AGX board.
If the device is on and sending data when I power on the AGX it seems that it will not boot up properly. Connecting the device after boot up works with no problems.

I have changed default debug port to be port 2.

Is this a known issue? Either with data at boot up or with the reasignment of the debug port.

I have not put a lot of time into investigating this. I do know that it is not consistent though. I have been able to boot up normaly with the device connected.

/Martin

akidder

1519 Posts
Posted - 19 Feb 2004 :  11:42:34  Show Profile  Email Poster
We're taking a look at this and will let you know what we find!
Go to Top of Page

mfh

10 Posts
Posted - 19 Feb 2004 :  11:50:42  Show Profile
I have looked a bit more at this.

For me the board fails to start about 50% of the time when I have the device connected (in this case a GPS). I have not tried any other ports.

/Martin
Go to Top of Page

Consultpinnacle

29 Posts
Posted - 22 Oct 2004 :  03:00:02  Show Profile  Email Poster
I am having the same issue with my debug port re-assigned to COM 1 and a GSM modem on COM 3.
It all works fine if the modem is set to communicate at 9600 baud, but if I increase the speed CE starts only 50% of the time.

Graham
Go to Top of Page
  Topic  
 Forum Locked
 Send Topic to a Friend
 Printer Friendly
Jump To:
Eurotech Support Forums © Eurotech Inc. Go To Top Of Page
This page was generated in 0.02 seconds. Snitz Forums 2000