All Forums
 Microsoft Windows CE
 General CE
 Connection failed debugging over ethernet		  Forum Locked
 Send Topic to a Friend
 Printer Friendly
Author Topic  

Tim

39 Posts
Posted - 09 Jan 2008 :  12:01:38  Show Profile  Email Poster
While trying to debug using CE 5.0 and Visual Studio 2005 I get a connection failed 0x8973151A message. This has worked in the past, but I haven't tried it in a few months. The device is available on ethernet (I can ping it) and the IP address is correct.

Any clue what this message is?
What can I do to figure this out?

Thanx!

grenierm

133 Posts
Posted - 10 Jan 2008 :  17:31:40  Show Profile  Email Poster
Hi Tim, thank you for your question.

The first thing to check is whether you have been following our setup procedure for debugging over ethernet, found under forum topic 2201.

The next thing to check is whether you are using the same build as before?

Another thing to do is to make sure that you have disabled your Windows Firewall on your PC.
Go to Top of Page

ctacke

877 Posts
Posted - 10 Jan 2008 :  19:46:01  Show Profile  Email Poster
Have you, by chance, installed Studio 2008 on the same development PC since it was working?
Go to Top of Page

Tim

39 Posts
Posted - 15 Jan 2008 :  12:33:06  Show Profile  Email Poster
Yes I have. I'm using VS 2005, but I have VS 2008 installed. It was working fine before installation. Now it is not working.
Edited by - Tim on 15 Jan 2008 12:33:54
Go to Top of Page

grenierm

133 Posts
Posted - 15 Jan 2008 :  17:48:56  Show Profile  Email Poster
You may need to recopy the files found here:
C: Program Files -> Common Files -> Microsoft Shared -> CoreCon -> 1.0-> Target -> wce400 -> armv4i

Onto the following location in the device:
My Device -> Windows

Then continue with the process found under forum topic 2201.
Go to Top of Page
  Topic  
 Forum Locked
 Send Topic to a Friend
 Printer Friendly
Jump To:
Eurotech Support Forums © Eurotech Inc. Go To Top Of Page
This page was generated in 0.03 seconds. Snitz Forums 2000