All Forums
 Microsoft Windows CE
 CE Downloads and Documents
 64M RAM		  Forum Locked
 Printer Friendly
Author Topic  

gesslingd

2 Posts
Posted - 24 Mar 2003 :  19:42:49  Show Profile
We just had some Graphics Master boards upgraded from 32 to 64 M RAM.
Then loaded our own CE image. Now I can't get them to run. I changed the .HWT file to:
0x00B002AD 0xC9600000 ; 10MB CE, 64 MB RAM
I can't get CE to boot.
What else do I need to change?

ctacke

877 Posts
Posted - 25 Mar 2003 :  09:13:33  Show Profile
When the RAM is upgraded in a CE system, you need 4 things:
  1. A new Boot ROM. This should have been installed when it was upgraded

  2. Modifications to ADSLOAD.HWT. This tells the system where in memory to put the image.

  3. Modifications to ADSLOAD.REG. This tells the Flash driver how big to make the FlashFX Disk.

  4. A new 64MB DRAM CE image. Each image contains information on where to load an the jump point for entry. This is different between 32 and 64MB images.


It sounds like you may still need to address #4 above. Download a new 64MB DRAM image and upgrade your system (explained further in the Developer's Getting Started Guide). If it still fails, email us the debug output from the device.
Go to Top of Page
  Topic  
 Forum Locked
 Printer Friendly
Jump To:
Eurotech Support Forums © Eurotech Inc. Go To Top Of Page
This page was generated in 0.02 seconds. Snitz Forums 2000