All Forums
 Hardware
 General Hardware, ADSmartIO, Digital I/O and A/Ds
 BitsyPlus A/D VRef		  Forum Locked
 Printer Friendly
Author Topic  

shilliard

4 Posts
Posted - 10 Feb 2004 :  10:51:33  Show Profile
Is the VRef pin an input or output? Is it possible to adjust its value to say 1.2V instead of 2.5V?

Thanks

akidder

1519 Posts
Posted - 10 Feb 2004 :  11:08:54  Show Profile
Vref is an output. It's the reference voltage used for the ADSmartIO A/Ds. You can't draw any power from it, but you can use it as a reference.

You could get 1.2V from it via a high-impedance voltage divider, but make sure you're not drawing any more than 100uA through the divider.

I guess it's possible that we could change the reference voltage to be 1.2V, if that's what you're asking. It would require a special factory configuration of your device. If you're interested, let us know the details of what you're trying to do.

Cheers, Drew
Go to Top of Page
  Topic  
 Forum Locked
 Printer Friendly
Jump To:
Eurotech Support Forums © Eurotech Inc. Go To Top Of Page
This page was generated in 0.02 seconds. Snitz Forums 2000