All Forums
 Hardware
 Displays
 Display not working but debug says I've booted OK		  Forum Locked
 Send Topic to a Friend
 Printer Friendly
Author Topic  

KnowledgeBase

296 Posts
Posted - 26 Feb 2002 :  15:55:09  Show Profile  Email Poster
Q: I can see on the debug port that my system is booting correctly, but my display isn't working.


  1. Make sure that the panel display cable is plugged in securely at both ends.
  2. If the display is always dark, the backlight cable might have been unplugged.
  3. Did you change the registry file or hardware table? If so, try going back to one that worked before.
  4. For Thin Client, did you change the settings on the connector board DIP switch? Those settings affect mapping of the display lines.



------------------
ADS Knowledge Base
  Topic  
 Forum Locked
 Send Topic to a Friend
 Printer Friendly
Jump To:
Eurotech Support Forums © Eurotech Inc. Go To Top Of Page
This page was generated in 0.02 seconds. Snitz Forums 2000