All Forums
 Hardware
 Displays
 Using the Graphics Client Hirose connector		  Forum Locked
 Send Topic to a Friend
 Printer Friendly
Author Topic  

KnowledgeBase

296 Posts
Posted - 26 Feb 2002 :  16:15:26  Show Profile  Email Poster
Q: I would like to use the Hirose connector on the back of the Graphics Client to control my panel. Is there anything I need to know to do this?

This connector is configured for a one-to-one cable to a Sharp LQ64D343 panel running in 16-bit mode. This connector wiring is found in other panels, too. Note that if you use this connector with a panel driver configured for 8-bit mode, the pin assignments are different (StrongARM architecture). Finally, this connector is not suitable for many passive panels as it does not have the Panel_Enable or VCON signals.



------------------
ADS Knowledge Base
  Topic  
 Forum Locked
 Send Topic to a Friend
 Printer Friendly
Jump To:
Eurotech Support Forums © Eurotech Inc. Go To Top Of Page
This page was generated in 0.02 seconds. Snitz Forums 2000