All Forums
 Microsoft Windows CE
 General CE
 Trouble Moving Debug to Comm1
 Forum Locked
 Send Topic to a Friend
 Printer Friendly
Author Topic  

Tools for Bending

13 Posts

Posted - 19 May 2004 :  13:10:09  Show Profile  Email Poster
I’m having trouble redirecting the debug port from comm3 to comm1

I have a Graphics Master card with the following HWT & REG files. Copied with “Hyper Terminal capture “prier to any changes

; ADS WinCE Hardware Table
;
; 25mar02 700110-97113 ak
; Synchronize with 700110-9701A-7
; - updates CL setting
; - updates LQ64D343 display timings
; - adds configuration notes (below)
; - adds comments about use of debug port


;
; ADS WinCE Registry File
;
; 25mar02 700110-97113 ak
; - Synchronize with 700110-9701A-7

I downloaded Zip file 700110-97113 from the archive and made 1ea. Change to both the hardware table and the registry

HWT:

; Configuration as released by ADS:
; 64MB RAM
; 32MB flash
; 10MB CE image
; 21MB FlashFX disk
; System clock 206MHz
; Sharp LQ64D343 6.4" VGA display @ 8bpp


;
; Changes made by developer: Debug output redirected to com1 J.C.



; Debug port output
; - Initial debug port output always comes out Serial Port 3.
; - Redirect becomes active after CE is launched.
; - The "Suppress" entry turns off debug port output after the
; message, "CE starts From DRAM" has been displayed
; - To use debug menu or to view CE load status, use Serial 3
; - Boot ROMs 1.79 and later allow you to suppress all output
; from the debug port by setting DIP switch 2 ON
0xC0000F48 0x00000001 ; Debug output: 01=COM1 02=COM2 [03=COM3]
0xC0000F40 0x00000000 ; Debug output: [00=show] 01=suppress


REG:

;
; Changes made by developer: Changed HKEY_LOCAL_MACHINE\Ident to TFB"xxxx" x's = Display number J.C.


;---------------------------------------------------------------------
[HKEY_LOCAL_MACHINE\Ident]
"Name"="TFB0002"
"OrigName"="GMaster"
"Desc"="ADS Graphics Master StrongARM Single Board Computer"

;---------------------------------------------------------------------


At Changes made by developer all was on 1 line behind the “;” to keep it “REMED OUT”

After copying in the new settings I reset and all booted fine but I didn’t get communication at com3 for my app. Or debug at comm1

I reconnected com3 to Hyper Term to find Debug still there I recaptured. It was garbled with formatting errors but showed the change to comm1.

Is there something I missed?




Edited by - Tools for Bending on 21 May 2004 10:31:55
  Topic  
 Forum Locked
 Send Topic to a Friend
 Printer Friendly
Jump To:
Eurotech Support Forums © Eurotech Inc. Go To Top Of Page
This page was generated in 0.01 seconds. Snitz Forums 2000