Eurotech Support Forums - My system goes to sleep or resets after booting

All Forums

General CE

My system goes to sleep or resets after booting

Forum Locked

Author

Topic

KnowledgeBase

296 Posts

Posted - 26 Feb 2002 : 16:44:54

Q: My system goes to sleep or resets once CE has booted completely.

JP5 (sleep voltage selector) may not be set correctly. Make sure that the voltage selected always has power applied to it. If you do not have an external, "permanent" power source connected to pin 6 of J5, set JP5 to 2-3 to use the 5V input power.
Your 5V power may be dropping out of regulation under load. Make sure the 5V power input isn't any lower than 4.75V

Applicability: Graphics Client Plus, Graphics Master

------------------
ADS Knowledge Base

Topic

Forum Locked

Jump To:

Eurotech Support Forums

This page was generated in 0.02 seconds.