All Forums
 Microsoft Windows CE
 General CE
 System starts first time, but won't start again		  Forum Locked
 Send Topic to a Friend
 Printer Friendly
Author Topic  

KnowledgeBase

296 Posts
Posted - 26 Feb 2002 :  09:16:10  Show Profile  Email Poster
Q: When I loaded a new CE image on my system, it booted ok the first time. But the next time it hung up at the "CE starts from DRAM" message. What happened?

Most likely you specified the wrong start address or size of the flash disk. The flash disk formatted over part of the CE image you loaded. To correct this problem, make sure you set the flash disk size so that the sum of the CE image size and flash disk size add up to 1MB less than the amount of flash you have on your system.



------------------
ADS Knowledge Base
  Topic  
 Forum Locked
 Send Topic to a Friend
 Printer Friendly
Jump To:
Eurotech Support Forums © Eurotech Inc. Go To Top Of Page
This page was generated in 0.02 seconds. Snitz Forums 2000