All Forums
 Microsoft Windows CE
 eVC Application Development
 Connection failure with Graphics Client Plus		  Forum Locked
 Send Topic to a Friend
 Printer Friendly
Author Topic  

KnowledgeBase

296 Posts
Posted - 26 Feb 2002 :  13:09:14  Show Profile  Email Poster
Q: Application debugging worked on my old Graphics Client, but on my new Graphics Client Plus system I get the error, "Connection to the device/emulation failed." All other remote tools work fine. What gives?

ADS CE build 2.06 and later include a patch that tells CE that the SA1110 is a StrongARM processor. Without that information, the CE remote debugger cannot create a remote session. You can tell if your build supports this correction by looking at the processor type under System Properties in the Control Panel. It should be listed as "StrongARM."



------------------
ADS Knowledge Base
  Topic  
 Forum Locked
 Send Topic to a Friend
 Printer Friendly
Jump To:
Eurotech Support Forums © Eurotech Inc. Go To Top Of Page
This page was generated in 0.02 seconds. Snitz Forums 2000