All Forums
 Hardware
 General Hardware, ADSmartIO, Digital I/O and A/Ds
 USB Open Load detection not supported??		  Forum Locked
 Printer Friendly
Author Topic  

mwmock

8 Posts
Posted - 22 Jun 2003 :  13:23:10  Show Profile
The MIC2506 power switch on the BitsyX connector board supports USB open-load detection only with a pull-up on the output. The BitsyX connector board has no such pull-up. Is this deliberate? Does the USB driver not want to see USB-PWR-SENSE asserted with an open load?
  Topic  
 Forum Locked
 Printer Friendly
Jump To:
Eurotech Support Forums © Eurotech Inc. Go To Top Of Page
This page was generated in 0.02 seconds. Snitz Forums 2000