All Forums
 Hardware
 Cables and Connectors
 JTAG & BitsyX		  Forum Locked
 Send Topic to a Friend
 Printer Friendly
Author Topic  

madav

15 Posts
Posted - 21 Nov 2003 :  12:08:38  Show Profile  Email Poster
Hi

I am trying to JTAG a ‘rev.A BitsyX’ board using the ‘720040-00031’ JTAG software.

I get an error informing me “Check ID Failed to read device ID for the XR3064”

The sequence of steps I followed is
1. Initialize GiveIO driver
2. Connect the pins, turn on power to the board
3. Started the Jtagc0.exe application
4. Entered adsload.rom when prompted for the name of the binary file.

Could you tell me where I am going wrong?

Also, If the process requires a software update, could you tell me as to when I can expect it.

Thanks

Madav

akidder

1519 Posts
Posted - 21 Nov 2003 :  13:57:26  Show Profile  Email Poster
Hi Madav. As we discussed, the problem you've experienced is likely due to a change in the internal revision code of a device in the JTAG chain, which the JTAG application doesn't recognize.

We've seen this problem and have moved to using the jflashmm application from Intel.

I regret it's taken a while to put together the package of configuration files you'll need for the BitsyX. We'll get them out to you shortly.
Go to Top of Page

madav

15 Posts
Posted - 21 Nov 2003 :  14:42:37  Show Profile  Email Poster
Thank You
Go to Top of Page

akidder

1519 Posts
Posted - 25 Nov 2003 :  18:04:21  Show Profile  Email Poster
The package worked for Madav. I've updated the information at JTAG topic 653 for those interested.
Go to Top of Page
  Topic  
 Forum Locked
 Send Topic to a Friend
 Printer Friendly
Jump To:
Eurotech Support Forums © Eurotech Inc. Go To Top Of Page
This page was generated in 0.03 seconds. Snitz Forums 2000