All Forums
 Microsoft Windows CE
 CE Flash, CF and PCMCIA
 Problem with loading reg file from PCMCIA
 Forum Locked
 Send Topic to a Friend
 Printer Friendly
Author Topic  

iei

4 Posts

Posted - 01 Jul 2004 :  13:43:12  Show Profile  Email Poster
Hi,
I need to reload adsload.reg file from PCMCIA card. Unfortunately, in boot mode bootloader does not read it. All topics in this forum were checked and instructions followed up. The card is 64MB. It has only one 32 MB partition (created and formatted on other GCPlus device as FAT16). FlashCard is successfully recognized on other ADS GCPlus devices in normal operation mode.

Please, explain how to operate.
Here is the debug message output:

> Failed to load ADS.HWT from an ATA flash PC card.
> Reading Flash Header Size...(0x1083 bytes)
> Reading Flash ...(from 0x40004 to 0x41087)
> Reading hardware register values from flash.
>
> This is Color, 8 Bit, Active Panel.(Width = 640, Height = 480)
> 8 BPP Color.
>
>ADSLOAD.BMP : Reading ... Writing...
> Failed to load ADSLOAD.BMP from an ATA flash PC card.
>
>ADSLOAD.HWT : Reading ... Writing...
> Failed to load ADSLOAD.HWT from an ATA flash PC card.
>
>ADSLOAD.REG : Reading ... Writing...
> Failed to load ADSLOAD.REG from an ATA flash PC card.
>
>ADSLOAD.EXE : Reading ... Writing...
> Failed to load ADSLOAD.EXE from an ATA flash PC card.
>
>NKLOAD.BIN : Reading ... Writing...
> Failed to load NKLOAD.BIN from an ATA flash PC card.
> Reading Flash Header Size...(0x1083 bytes)
> Reading Flash ...(from 0x40004 to 0x41087)
> Reading hardware register values from flash.
>
> Booting from Flash.
> Reading Flash Header Size...(0xe60658 bytes)
> Reading Flash Header Size...(0xc8100000 bytes)
> Reading Flash ...(from 0x200008 to 0x01060660)
>
> CE starts From DRAM(0xc8100000)
>
>Windows CE Kernel for ARM Built on Feb 12 2003 at 15:37:33
>ProcessorType=0b11 Revision=9
>sp_abt=ffff5000 sp_irq=ffff2800 sp_undef=ffffc800
>Windows CE Image was built at 16:30:56 on Nov 6 2003.
>Saved Registry will be restored.
>Sp=ffffc7d0
> FlashFX Disk Detected: Ver 5.10 (Build 492)
> SMARTIO Detected : PartType:0x4434 Firmware:0x4017 Revision :N
> UCB1200 Detected : ID = 0x1004
>
>
> Microsoft Windows CE Ver. 4.10 (build 908)
>
> ADS GCPlus Windows CE Ver.(4.10.17)
>
>RaiseException: Thread=80eec000 Proc=801bebe4 'services.exe'
>AKY=00000021 PC=811078b4 RA=81105250 BVA=00000000 FSR=00000000
>
>* ADSLOAD.EXE(do-nothing build): Complete
>
  Topic  
 Forum Locked
 Send Topic to a Friend
 Printer Friendly
Jump To:
Eurotech Support Forums © Eurotech Inc. Go To Top Of Page
This page was generated in 0.02 seconds. Snitz Forums 2000