All Forums
 Hardware
 Displays
 VGX and monitor VGA
 Forum Locked
 Send Topic to a Friend
 Printer Friendly
Author Topic  

crf

7 Posts

Posted - 16 Sep 2005 :  05:58:24  Show Profile  Email Poster
I want to connect a VGA monitor using the correct cable from the J9 of the VGX board and the VGA out.
I have done the correct cable using the document of the Forum.
In the board I have Windows CE 4.2
The problem is that I don't see anything on the VGA monitor, while on the display of the ADS development kit I see correctly the ADS video output.
Do you have any suggestion?
Thanks in advance

hchin

30 Posts

Posted - 16 Sep 2005 :  16:58:24  Show Profile  Email Poster
Hello,

By default, if the LCD output is enabled then the VGA analog output is also enabled.

I suggest you check that to make sure you're using the correct document "610115-10302" at topic 1279.
If it is correct, then use an oscilloscope to probe the pins 8, 10, 12 on J9 to make sure you're are getting the signals. Also check pins 3 and 4.

Go to Top of Page
  Topic  
 Forum Locked
 Send Topic to a Friend
 Printer Friendly
Jump To:
Eurotech Support Forums © Eurotech Inc. Go To Top Of Page
This page was generated in 0.02 seconds. Snitz Forums 2000