All Forums
 Hardware
 Ethernet, IR, Serial, CAN and high speed data
 RS-485 termination
 Forum Locked
 Send Topic to a Friend
 Printer Friendly
Author Topic  

akidder

1519 Posts

Posted - 13 Mar 2002 :  15:59:37  Show Profile  Email Poster
Q: Is RS-485 terminated on your systems?

No. You must provide proper termination yourself at the ends of your RS-485 network.

-----------------------
Drew Kidder
ADS Technology Transfer

akidder

1519 Posts

Posted - 17 Sep 2002 :  17:51:11  Show Profile  Email Poster
Revisions D and later of the GC Plus include a jumper to add termination to the network. When you place a shunt across the header, it adds a 120 ohm terminator between the RS-485 RX+ and RX- pins.

On rev D GC Plus systems, the header is J20, a 0.100 inch Molex header. On rev F GC Plus systems, the terminator is J23, a two-pin 2mm header.

-----------------------
Drew Kidder
ADS Technology Transfer


Edited by akidder 11-Jul-2003: Add information about rev F J23 and include image.
Edited by ljoy 27-Sep-2007: Deleted image.

Go to Top of Page
  Topic  
 Forum Locked
 Send Topic to a Friend
 Printer Friendly
Jump To:
Eurotech Support Forums © Eurotech Inc. Go To Top Of Page
This page was generated in 0.02 seconds. Snitz Forums 2000