All Forums
 Microsoft Windows CE
 General CE
 Updating Flash Files on TurboG5		  Forum Locked
 Send Topic to a Friend
 Printer Friendly
Author Topic  

cbadr

154 Posts
Posted - 26 Jun 2009 :  18:00:21  Show Profile  Email Poster
Updating Flash Files on TurboG5

To update flash files on TurboG5, follow these steps:

- Monitor the output from the board's serial port on your terminal emulator while the system boots

- Press the space bar on your computer's keyboard when you see the following message displayed and a counter counting down:

  Press [SPACE] to enter Debug menu.
  Initiating image Run in n seconds.

- When the TurboG5 Boot Loader Debug Menu is displayed, type 1 to select the following option:

  (1) Update files from Storage card

NOTE: Do not disconnect power or reset the system before the operation of copying files to flash completes.
  Topic  
 Forum Locked
 Send Topic to a Friend
 Printer Friendly
Jump To:
Eurotech Support Forums © Eurotech Inc. Go To Top Of Page
This page was generated in 0.03 seconds. Snitz Forums 2000