All Forums
 Microsoft Windows CE
 .NET Application Development
 Detecting digital I/O with Zeus C#; audio output		  Forum Locked
 Send Topic to a Friend
 Printer Friendly
Author Topic  

tfillerup

6 Posts
Posted - 04 Jan 2010 :  16:13:40  Show Profile
Hello,

I am writing an application that will run on a Zeus board running Windows CE 5.0. I have a momentary switch plugged into the PTT pin on J9. Using c#.net, how will I be able to detect when that switch is pressed? Also, is there something special that I need to do to route the iO270 audio to the zeus board audio? I can hear windows sounds from my speakers, but i cannot hear the voice audio coming from the iO270.

thanks

Russ-Eurotech

273 Posts
Posted - 05 Jan 2010 :  12:10:20  Show Profile  Email Poster
"I have a momentary switch plugged into the PTT pin on J9.
Using c#.net, how will I be able to detect when that switch is pressed?"

It is a matter of reading a GPIO line.
Details are given on page 22 & 23 of the manual:
Zeus Technical Manual - click here

There are also examples for GPIO on the dev kit CD under:
\Examples\Evc\GPIOTest


"Also, is there something special that I need to do
to route the iO270 audio to the zeus board audio?
I can hear windows sounds from my speakers,
but i cannot hear the voice audio coming from the iO270."

Unfortunately, the audio doesn't go anywhere from the modem.
Basically the Zeus doesn't cater for it.
It is "data only" (via COM port)
Go to Top of Page
  Topic  
 Forum Locked
 Send Topic to a Friend
 Printer Friendly
Jump To:
Eurotech Support Forums © Eurotech Inc. Go To Top Of Page
This page was generated in 0.02 seconds. Snitz Forums 2000