All Forums
 Documentation
 Documentation
 Vulcan board changes from rev B to C?
 Forum Locked
 Send Topic to a Friend
 Printer Friendly
Author Topic  

Axion

2 Posts

Posted - 02 Feb 2010 :  14:53:52  Show Profile
Until recently we received Vulcan board that were identified as :
VULCAN V1 I5 @2005 B, but the last shipments were :
VULCAN V1 I5 @2005 C

Given the errors messages generated once we tried to work with them,
we suspected that the memory chip as been changed.

We would appreciate having detailed informations about that modification level 'C'.

Thank you

Russ-Eurotech

273 Posts

Posted - 02 Feb 2010 :  15:02:25  Show Profile  Email Poster
Hello Yves,

I'm investigating this for you and will email you the ECO details for the Revision B and C of the Vulcan.

In short, one modification was a change of Processor part, and the other was a change of the Flash part.

So yes, I believe you are correct that a Rev C board will have a different onboard Flash part than your previous ones did.

Thank you,
~Russ
Go to Top of Page

akidder

1519 Posts

Posted - 02 Feb 2010 :  15:53:28  Show Profile  Email Poster
Could you give us a brief sample of some of the error messages you are seeing? Also what operating system are you using?
Go to Top of Page

Axion

2 Posts

Posted - 04 Feb 2010 :  08:31:20  Show Profile
Hello,
Following a 'Make.jffs2', this error message appears :
'CLEANMARKER node found at 0x00050000, not first node in block (0x0040000)'.
For both Redboot and Linux.
Thank you
Go to Top of Page
  Topic  
 Forum Locked
 Send Topic to a Friend
 Printer Friendly
Jump To:
Eurotech Support Forums © Eurotech Inc. Go To Top Of Page
This page was generated in 0.02 seconds. Snitz Forums 2000