All Forums
 Embedded Linux
 Linux FAQ
 Viewing debug port output		  Forum Locked
 Send Topic to a Friend
 Printer Friendly
Author Topic  

KnowledgeBase

296 Posts
Posted - 18 Apr 2002 :  09:36:19  Show Profile  Email Poster
Note that this topic only applies older boards. For more current information see Identifying Serial Ports.

Q: How do I get debug messages from my ADS development system?

The Linux Boot ROM uses Serial 3 for debug output. Configure your PC terminal application for 38400 bps, 8 data bits, no parity, 1 stop bit and no flow control.

Serial 3 is found on J10 of the GraphicsClient Plus and GraphicsMaster and on J18 of the Bitsy and Bitsy Plus connector boards.
Edited by - adrian on 10 Jan 2008 20:01:01
  Topic  
 Forum Locked
 Send Topic to a Friend
 Printer Friendly
Jump To:
Eurotech Support Forums © Eurotech Inc. Go To Top Of Page
This page was generated in 0.02 seconds. Snitz Forums 2000