All Forums
 Hardware
 Displays
 VEE on Bitsy		  Forum Locked
 Send Topic to a Friend
 Printer Friendly
Author Topic  

gcardwel

3 Posts
Posted - 02 Jul 2002 :  19:15:16  Show Profile  Email Poster

The Bitsy manual says that VEE is "installed only as an option and is not installed on all Bitsy Boards".



So questions then:



How do you know if your Bitsy has VEE support?



I have tried, without success, to find a J7 (Flat Panel VEE Select) on the Bitsy I have. Where is J7 located?

akidder

1519 Posts
Posted - 03 Jul 2002 :  09:52:49  Show Profile  Email Poster
The entry in the manual for Vee Select is listed incorrectly. It should read "JP5," not "J7." I've noted the correction in the Bitsy manual errata. Thanks for pointing it out.

There are a couple components that will help you spot if Vee is installed. If any of the following components is missing, Vee is not available (additional components may not be populated):
    D10 (underside of board, next to 16-pin U22 and yellow capacitors C105 and C100)
    JP1 and JP2 (near PCMCIA ejector button)
    JP5 (other side of ejector, next to LED)


If you have an application that requires Vee for your display, Eurotech will factory-configure the Bitsy for your display. Contact our Sales Group with details about your requirements.

-----------------------
Drew Kidder
ADS Technology Transfer
Go to Top of Page
  Topic  
 Forum Locked
 Send Topic to a Friend
 Printer Friendly
Jump To:
Eurotech Support Forums © Eurotech Inc. Go To Top Of Page
This page was generated in 0.02 seconds. Snitz Forums 2000