All Forums
 Hardware
 Cables and Connectors
 Pinout for LS520 backlight cables		  Forum Locked
 Send Topic to a Friend
 Printer Friendly
Author Topic  

akidder

1519 Posts
Posted - 27 Jan 2003 :  17:16:06  Show Profile  Email Poster
LS520 Backlight Cable

The following is the cable currently used for backlight inverters on standard development systems. The cable is a straight-through (pin 1 to pin 1) seven-conductor cable that uses the Molex 51021 connectors on both ends. It connects our systems to the Taiyo-Yuden (Xentek) LS520 backlight inverter. The cable drawing is shown below.

The part number for this cable is 600000-1014A, while Quadrangle, its manufacturer, calls this cable QD3105-9 or 51021-2-0700-9.00". The "9" at the end of the Quadrangle part numbers is the length in inches. Our part number 600000-1014B corresponds to the 15-inch QD3105-15.

For further details about backlight inverters, consult the backlight topic index.


Edited by akidder 9-May-2003: Add link to Quadrangle Products.
  Topic  
 Forum Locked
 Send Topic to a Friend
 Printer Friendly
Jump To:
Eurotech Support Forums © Eurotech Inc. Go To Top Of Page
This page was generated in 0.02 seconds. Snitz Forums 2000