All Forums
 Microsoft Windows CE
 General CE
 ADSLOAD.HWT for GCX		  Forum Locked
 Send Topic to a Friend
 Printer Friendly
Author Topic  

crf2

8 Posts
Posted - 21 Jun 2007 :  08:41:08  Show Profile  Email Poster
Hi,

I'm trying to boot WinCE 4.2 on a CGX board, from ATA.
Which ADSLOAD.HWT should I use for correct boot ? Where can I download it ?

When I switch on the system (SW1 switches: OFF OFF ON OFF), hyperterminal doesn't show the boot procedure! Could it depends on an inaccurate ADSLOAD.HWT file ?

Thank you

jjoseph

47 Posts
Posted - 22 Jun 2007 :  19:17:53  Show Profile
If you are using a GCX Dev system with a 4 wire touch panel you can now download the configuration files (including adsload.hwt and adsload.reg) from topic 1496.

The setting of your boot switches should not change the debug output, but your adsload.hwt can. See the first column of your Getting Started manual section 3.1.1 for boot switch settings needed to load new config files.
Go to Top of Page
  Topic  
 Forum Locked
 Send Topic to a Friend
 Printer Friendly
Jump To:
Eurotech Support Forums © Eurotech Inc. Go To Top Of Page
This page was generated in 0.02 seconds. Snitz Forums 2000